Matronics Email Lists

Thank you very much for the information. I'll use the RTV (and my 9 year old!) to keep everything in place while installing.

I currently have the stock exhaust disassembled on my AG5B for an exhaust leak at a couple of the flanges. I have everything cleaned up, trued up, new clamps, gaskets, and attaching hardware. Was wo ...

I'll give them a call tomorrow- thank you!

Where is the best place to get new exhaust clamps? AG5B, stock exhaust. Thank you.

Thank you Gary.

I have a 2001 AG5B Tiger and want to upgrade to the 406 MHz ELT. If anyone has already done this, where did you mount your antenna? Thanks, Curt

Thanks Bob, I guess I'll find out when I pull the alternator. Hopefully they didn't just crimp it in with another wire on the same connector.
-Curt

Alternator light update- Removed the cowling for annual today and found the "AUX" wire pulled loose from the alternator. I have looked through every diagram I have and cannot find definitiv ...

Ned,
Thanks again- I forgot to mention that I put a brand new master switch in also. Throwing new parts at a problem is not the most cost effective way of troubleshooting... but sometimes the quicke ...

Ned and Gary,
Thank you both very much for the quick, and thorough, responses. I’ll attach a picture of the amber Alternator light- top left panel. I have the Zeftronics 24v solid state voltage r ...

I have a 2001 AG5B with an intermittent flickering alternator light. My JPI EDM 700 always shows over 28vdc- so the alternator is definitely charging. I have changed the voltage regulator but the fl ...

Thank you for all of the great information- especially the discussion on the differences between EI and JPI probes. One bit of information I left out- the mags were timed exactly to 25 degrees BTDC ( ...

What should the cylinder head temperatures indicate on a later model AG5B with good seals/ baffles? Everything I have read says to keep the CHT’s below 400 degrees, but I am not having much success ...