Matronics Email Lists

Thanks Bob.
When I looked at length it was no longer than 3 feet battery to starter motor.
All your drawings had 4AWG not sure why that was and so I just had to ask.
Chris.

Thanks Bob.
When I looked at length it was no longer than 3 feet battery to starter motor.
All your drawings had 4AWG not sure why that was and so I just had to ask.
Chris.

Guys just got my Spruce order sent down under.. You don't what to know the shipping price.
Anyway I ordered some colored battery wire thinking it was 4awg and find out its 6 awg.

How critical i ...

with the value of the Australian $ I would go for the cammit engine.. Just like a 3300 only better..
Chris

Hi
Has anyone done an installation of Rotec Liquid Cooled Heads for Jab3300 in a 601/650?

I have bought a set and wanted to install it on my Jab 3300. Wanting to talk with anyone who has don it a ...

Hi
I can't find in the plans the new rear spar 5/16th bolt size after the upgrade
6-ZU-2 has the fwd spar but where is the rear Spar bolt part number
Chris

Thanks guys
I will leave the strut alone as I can always drill it later.
I have also made a ring to attach for steering.
And I will try and not hard land.
Chris

Hi
I am getting back into building after a break and revisiting the nose gear area.
I have hand written notes about drilling a drain hole in the bottom of the main nose strut at the bottom.
Was thi ...

Paul
The front holes were done already and so it's just the rear hole and alignment checks.
Chris

I am tinkering with the same idea but will use the smaller dimmer from aircraft spruce.. Saved money on the lights and will use it to spend on the dimmer.
Cris

Hi everyone
I have finally finished enough to join the wings to the fuse next week.
I can't find any info in the photo guides on drilling the back spar hole
There is a little info in page 6-S-3 o ...

Thanks Bob.
I got abut worried when I realised it also was for a 3 phase system.
Chris

Hi All

I bought ages ago a PM/OV Filter and OV Protection Kit (14v) that I intended to fit to my Jab 3300.

Now I have come to the fitting end and wonder if it is still the right part for my Sin ...

Hi mate

so how was it blocked..
is it something to watch when doing an install?
Chris..

bob
what size wire did you use??
and was it a CS01 or a 02?
Chris

Hi all
> I am installing a Grand Rapids J6000 EIS in my aircraft.
> > Where have people wired the amp current sensor? and through whit size
> > wire was it?
> > There are 2 ...

I am doing the front canopy XL bolts and have a couple of Q's

1. How many washers should be between the head and nut.
The plans call for 2 washers between the 6-C3-6 and the steel 6C2-3 and the ...

Hi all
I am running my wires and coax for my radio and intercom. I also have a Dynon Ext compass wires to run as well.

If i run the compass and VHF coax together in the one bundle, will I get a ...

Hi
has anyone used the Sensenich Ground adjustable carbon fiber 2 or 3 blade prop on a 912?

looking at putting a new prop on a sportstar.. anyone have real world experiences?
Chris

guys and girls
when you mounted the Compass unit down the back, where did you run the cable from the Dynon 100?
I was thinking down the LH side above the vertical uprights ,although that is also wh ...