Matronics Email Lists Forum Index Matronics Email Lists
BBS Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Search found 13 matches
Matronics Email Lists Forum Index
Author Message
  Topic: Aera 660 Bare Wire Cradle Question
farmrjohn

Replies: 17
Views: 365

PostForum: AeroElectric-List   Posted: Tue Jun 11, 2019 6:34 am   Subject: Re: Aera 660 Bare Wire Cradle Question

but the current installation manual, dated 6 months later, states:
"A three conductor shielded cable 24 AWG or heaver,
Hmmm . . . . Given the short runs and low
power levels it seems ...
  Topic: Aera 660 Bare Wire Cradle Question
farmrjohn

Replies: 17
Views: 365

PostForum: AeroElectric-List   Posted: Sun Jun 09, 2019 12:29 pm   Subject: Re: Aera 660 Bare Wire Cradle Question
Some confusion on wiring the RS-232 signal to the ELT has cropped up. There is no power out provision from the 660 cradle to provide power to the ELT which ACK requires (protected by 1 amp fuse/cb). ...
  Topic: Aera 660 Bare Wire Cradle Question
farmrjohn

Replies: 17
Views: 365

PostForum: AeroElectric-List   Posted: Thu May 30, 2019 12:02 pm   Subject: Re: Aera 660 Bare Wire Cradle Question

> >
If it were my airplane:



Thanks, I hadn't considered cutting the 660 harness. For connections I'm planning on Red to power (from aux plug that the current plug in harness goes ...
  Topic: Aera 660 Bare Wire Cradle Question
farmrjohn

Replies: 17
Views: 365

PostForum: AeroElectric-List   Posted: Wed May 29, 2019 12:39 pm   Subject: Re: Aera 660 Bare Wire Cradle Question
Sent from At 04:02 PM 5/28/2019, you wrote:
--> AeroElectric-List message posted by: "farmrjohn" <faithvineyard>

Bare Wire Question, Part II. I asked Garmin about the AWG ...
  Topic: Aera 660 Bare Wire Cradle Question
farmrjohn

Replies: 17
Views: 365

PostForum: AeroElectric-List   Posted: Wed May 29, 2019 12:22 pm   Subject: Re: Aera 660 Bare Wire Cradle Question
Digikey has D-Sub contacts made for 28 AWG wire. Mouser also has them but their search engine makes them hard to find unless you search for the manufacturer's part number. Be careful not to buy the ...
  Topic: Aera 660 Bare Wire Cradle Question
farmrjohn

Replies: 17
Views: 365

PostForum: AeroElectric-List   Posted: Tue May 28, 2019 1:02 pm   Subject: Re: Aera 660 Bare Wire Cradle Question
Bare Wire Question, Part II. I asked Garmin about the AWG for the wires in the harness. Their reply 20AWG for power and ground, and 26AWG or 28AWG for the others. The pins I see online at Aircraft ...
  Topic: Aera 660 Bare Wire Cradle Question
farmrjohn

Replies: 17
Views: 365

PostForum: AeroElectric-List   Posted: Sat May 25, 2019 12:38 pm   Subject: Re: Aera 660 Bare Wire Cradle Question
If the GPS has a male connector and the aircraft wiring has the female connector, then there is less chance of accidentally shorting out the power wires.

Thanks. Would connector shells be necessar ...
  Topic: Aera 660 Bare Wire Cradle Question
farmrjohn

Replies: 17
Views: 365

PostForum: AeroElectric-List   Posted: Thu May 23, 2019 6:31 pm   Subject: Aera 660 Bare Wire Cradle Question
NOOB question: I have a Garmin Aera 660 that I'd like to use their bare wire cradle to connect to aircraft power and utilize the 232 and audio outputs. Is the best way to do that is connect all nine ...
  Topic: Alternator Lead Wiring Component?
farmrjohn

Replies: 2
Views: 333

PostForum: AeroElectric-List   Posted: Mon Jan 28, 2019 7:08 pm   Subject: Re: Alternator Lead Wiring Component?
Thanks for the information. There is also a noise filter on the lead from the control switch to the (I) terminal on the regulator. They must not do any harm since the radio is clear. I'll just leav ...
  Topic: Alternator Lead Wiring Component?
farmrjohn

Replies: 2
Views: 333

PostForum: AeroElectric-List   Posted: Sat Jan 26, 2019 12:46 pm   Subject: Alternator Lead Wiring Component?
I'm trying to sort the wiring layout on my newly acquired plane. It has a TCM 60 alternator and Zeftronics 15100 regulator which has (I) (A) (S) (F) terminals. The (S) terminal is not being used. T ...
  Topic: Stratux alternative ADS-B antennas?
farmrjohn

Replies: 3
Views: 366

PostForum: AeroElectric-List   Posted: Sun Jan 06, 2019 9:03 am   Subject: Re: Stratux alternative ADS-B antennas?
Thanks for the tip on the remote mount. Now I'm also considering switching to the remote gps antenna. That way the stratux could be mounted in the shade vs. in direct sunlight even though it has a b ...
  Topic: Stratux alternative ADS-B antennas?
farmrjohn

Replies: 3
Views: 366

PostForum: AeroElectric-List   Posted: Sat Jan 05, 2019 3:34 pm   Subject: Re: Stratux alternative ADS-B antennas?
I have received the components and assembled the Stratux. Is the reason it uses two separate antennas for the two ADS-B frequencies because the computer board takes two USB receivers, one for each fr ...
  Topic: Stratux alternative ADS-B antennas?
farmrjohn

Replies: 3
Views: 366

PostForum: AeroElectric-List   Posted: Wed Jan 02, 2019 12:42 pm   Subject: Stratux alternative ADS-B antennas?
Hi, new to the list. I'm interested in a Stratux for ADS-B in but would prefer a less visible antenna array for the ADS-B. Are there alternatives? I'm planning on powering the unit via aircraft pow ...
 
Page 1 of 1
All times are GMT - 8 Hours
Jump to:  


Powered by phpBB © 2001, 2005 phpBB Group