Matronics Email Lists

Has anyone had any joy with obtaining the A3 ply templates from Europa which used to be in the manual, or could email me a copy to print? Its the one in the tailplane that I need. Thanks

So Rob Martin just made me a set of Nev Cowlings for K365 and I am busy trying to work out if I have to use standard Europa ducting, radiators, plenum etc. Seems that I dont but I will need details of ...

I just use an electric finger file on the rebate to take the shine right off. Next time around I shall make sure there is a 3 mm gap all round as a transition for any bits that end up slightly proud. ...

Was there any progress on finding the jig?
Can I get a copy of the drawings?
I assume the jig defines the landing gear holes and the rotax engine holes plus maybe provides some support for tubes whi ...

i am curious as to the incident that prompted this mod, how the LAA came to produce and issue it and also make the required parts available through its shop. Was the club involved?

Around 14:00 if anyone else fancies it and a circuit of the Breckon Beacons

Does anyone have controller for sale such as a CSC-1/G for a Woodcomp SR3000? i have the CSC-1/P but its not suitable sadly.

Does anyone have any insight into whats going on with Trutrak products now they are owned by Bendix king. Ive ordered a two axis autopilot and added wiring and other mod requirements to my build but c ...

Any suggestions on cockpit vents. I am not far off painting my fuselage but haven't added any vents yet. The supplied ones are not durable. I tried to get the ones Ivan was looking for but they are no ...

Are you the uk, if so i would ask Andy Draper at the LAA. What are the white spots ? Is that tge spar? Is it a Classic with a foam wing or an XS?

No stock at LAS, wondered if anyone had one kicking about either size (1.25 or 2.25), required for 914 install. i have the sender.
UK.
Also if anyone had the moulding left over for the side fuel inl ...

my take is that it is part of a basket of measures taken due to an unexplained accident i cardiff about 12 years ago. Europas had been flying without issue for probably 12 years before. it helps prev ...

Imagine changing all the rubber in a car after 7000 miles and 5 years. I did do mine at 6 years but after felt most was a waste of effort, it was all as new. And its not without risk either as you ne ...

where is it based?
I would say the value depends a lot on the fit, mods and history.
it has a cs orop - good, mode S? 833 radio.? pilot aware or flarm, smartass..
The instruments look traditional. ...

i just wired a rayallen g205 yesterday for P1, used the extra 2 switches for autopilot at hld and cws. for P2 i will use a rubber classic motorcycle handlebar grip and ptt on the dash. i am maybe jump ...

I had my Europa project on the drive a couple of days while weighing and plugging it all together and waggling the surfaces and after a couple of downpours was alarmed to see so much water coming in; ...

sush, sleeping;
Just submitted the paperwork for G-PATS for permission to test fly and initial permit. Been impressed with the classic cowl and engine fit (granted the radiators are a bit of work whe ...

ah ha, that's it then, the drawing shows AN5-40 which is too short, needs to be AN5-41 that's 1/8th longer. thanks

You can get the hinge from Europa, LAS aerospace or aircraft spruce. I doubt the wear would leave a round hole for an oversized pin. Could try a new pin easily though.

Im just fitting my 912 to LG01 (classic) and am having problems tightening sufficient to get split pins in (I recall my last build had some odd split binx nuts not these). I can get the nuts on but ca ...