Matronics Email Lists

What exactly do you mean by "straight back along the side"? The arc length of the outside of the tube would be drastically different than the arc length of the inside of the tube...... so s ...

One place in the Install manual it shows 3.93" from the head/flange, but it's unclear HOW EXACTLY you're measuring that (center of the exhaust in a bent tube, outside of the arc, inside of the ar ...

Haven't made final decision yet - wanted to move out of my old engine first before proceeding.

Hi guys, just wanted you to all know i have my Rotax 582 up
for sale. NO WEAR (video proof!) 126psi compression on
both cylinders. Honing marks inside the bore still look new!

It's currently m ...

I want to replace the rubber portion of the mounts, where
can I get just the rubber part? It measures up very close
to the ones in the CPS catalog with 4 mount holes instead
of two, but theirs has ...

Unfortunately it wasn't my choke after all. It's still running rich somehow. The float needle looks good, the enrichening circuit is not it (it's sealed tight after all even tho it was a little weak ...

It's seating correctly and adjust right, but either the haulback spring is bad or the cable is dragging. Does anyone have details on dissasembling these choke 'lever type' systems? I didn't assemble i ...

My carb choke cables and/or handle are hanging up. I find
I have to flip it back down, and then press IN on it to make
it stop choking the carbs.

Does someone know exactly step by step how to re ...

Tom Jones was correct - for some reason it was NOT dirt - I just
haven't utilized the choke enough to realize it was intermittently
hanging open. I apparently flipped it on to get her running afte ...

Well do you mean 'float valve'? Remember, the engine was running perfect just the day prior to my swapping out the rubber hoses - it's about 99% sure and obstruction in my book.

Well, I installed some new fuel line cause my old black rubber was
getting 'old'. Engine was dialed in PERFECTLY before this. Must have
dislodged some crap in the process.....

Now, one cylinder a ...

On my recently acquired Kitfox 3, I decided to replace
the coolant with DexCool (who knows what it had!)

I pulled the cyl head vent tube and found that the
metal nipple where the 1/4" tube p ...