Matronics Email Lists Forum Index Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
 
 Get Email Distribution Too!Get Email Distribution Too!    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Glasair-List Digest: 0 Msgs - 05/24/19

 
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Glasair-List
View previous topic :: View next topic  
Author Message
craymondw(at)aol.com
Guest





PostPosted: Tue May 28, 2019 7:50 am    Post subject: Glasair-List Digest: 0 Msgs - 05/24/19 Reply with quote

After my GL2SFT my nose wheel wear pad crumbled I purchased a piece of hard 5/16th inch hard shoe leather for $6.00 and cut out a new one on a band saw and used powerful gray marine epoxy to attach it to the backing and used graphite as a lubricant. A short while later I learned Glastar nose wheel wear pads were the same one used on Glasair FT and costs $43.00 and you have to say you own a Glastar in order for them to sell them to you. Leather was used as clutch and bearing materials all the way up to the late 1920's and I will provide up dates on how the leather holds up. I think the cause was oil and primer draining down the strut and soaking the old wear pad. After replacing the pad I used a tie wrap to direct oil and primer fuel away. My ex NASCAR mechanic IO 360 200HP rebuilt (jeff(at)a2z-aviation.com) using his custom designed exhaust system and Hartzels' Blended foil prop, with the engine finally braking in and I am showing consistent 226 mph ground speed at six to eight thousand feet alt. As a side note, in order to clear the the nose wheel assembly I had to use a 180 sump on my 200HP wide bank. I found when I filled the sump with nine quarts of oil the oil level covered the cylinder oil drain inlets and backed up the oil causing excessive oil consumption and found a six quart max ended the high consumption. I used a removed oil sump and learned the sump itself holds five quarts and adding another quart brings the oil level up to six would just clear the crankcase oil drain inlets.
--


- The Matronics Glasair-List Email Forum -
 

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?Glasair-List
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Matronics Email Lists Forum Index -> Glasair-List All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group