Matronics Email Lists :: View topic - Van's Whelen/ELT bracket

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Van's Whelen/ELT bracket

Matronics Email Lists Forum Index -> RV10-List

View previous topic :: View next topic

Author Message

msausen

Joined: 25 Oct 2007
Posts: 559
Location: Appleton, WI USA

Posted: Fri Jan 30, 2009 2:58 pm Post subject: Van's Whelen/ELT bracket

Whoever may have used this, where does it go and do you have the instructions that you can share.  I don’t think they are up on Tim’s site.  

   

Michael  

      [quote][b]

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

Jim Berry

Joined: 10 Jan 2006
Posts: 237
Location: Denver

Posted: Fri Jan 30, 2009 4:57 pm Post subject: Re: Van's Whelen/ELT bracket

Michael,



Mine is mounted 8" behind the baggage bulkhead on the left. Rivets to the upper and middle J channel with 8 pull rivets. I don't have the instruction sheet anymore, but it is stone simple. It will not fit on the right, but it would be easy to make a mirror image if you wanted one for elt and one for strobe pack.



Jim Berry

40482

Finishing the finishing

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

tsts4

Joined: 06 Aug 2007
Posts: 167
Location: Tampa, FL

Posted: Fri Jan 30, 2009 4:58 pm Post subject: Re: Van's Whelen/ELT bracket

I have the instructions but no way to post them electronically.  I can either type them out here (there's 5 steps) or if you post or PM me a fax number I can send them that way.



It gets installed between the F-1047C-L and F-1047D-L J-stiffeners, and between the F-1006 and f-1007 Frames, but closer to the F-1006.  You slide it fore and aft to get a good fit.  The outside face of the bracket's top flange goes against the bottom side of the 1047C stiffener, while the inside face of the bracket's bottom flange goes against the bottom side of the 1047D stiffener.  The instructions have a drawing that makes this arrangement perfectly clear.

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

_________________
Todd Stovall
aka "Auburntsts" on EAA and VAF
RV-10 N728TT -- Flying

rene(at)felker.com
Guest

Posted: Fri Jan 30, 2009 5:20 pm Post subject: Van's Whelen/ELT bracket

I don’t have the instructions on me, but I placed mine on the left side of the fuselage, about a foot behind the baggage compartment bulk head.  

     

Rene' Felker  

RV-10 N423CF Flying  

  

801-721-6080      

From: owner-rv10-list-server(at)matronics.com [mailto:owner-rv10-list-server(at)matronics.com] On Behalf Of RV Builder (Michael Sausen)

 Sent: Friday, January 30, 2009 3:43 PM

 To: rv10-list(at)matronics.com

 Subject: Van's Whelen/ELT bracket  

  

  

   

Whoever may have used this, where does it go and do you have the instructions that you can share.  I don’t think they are up on Tim’s site.  

   

Michael   	  Quote: 	
		    http://www.matronics.com/Navigator?RV10-List 	
0 	  Quote: 	
		   	
1 	  Quote: 	
		   	
2 	  Quote: 	
		   	
3 	  Quote: 	
		   	
4 	  Quote: 	
		   	
5 	  Quote: 	
		   	
6 	  Quote: 	
		   	
7 	  Quote: 	
		   	
8 	  Quote: 	
		   	
9

       [quote][b]

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

jesse(at)saintaviation.co
Guest

Posted: Fri Jan 30, 2009 8:18 pm Post subject: Van's Whelen/ELT bracket

You can fax them to me and I'll post the pdf that I get from my fax  

service.



do not archive



Jesse Saint

Saint Aviation, Inc.

jesse(at)saintaviation.com

Cell: 352-427-0285

Fax: 815-377-3694



On Jan 30, 2009, at 7:58 PM, tsts4 wrote:



 	  Quote: 	
		   



 I have the instructions but no way to post them electronically.  I  

 can either type them out here (there's 5 steps) or if you post or PM  

 me a fax number I can send them that way.



 It gets installed between the F-1047C-L and F-1047D-L J-stiffeners,  

 and between the F-1006 and f-1007 Frames, but closer to the F-1006.   

 You slide it fore and aft to get a good fit.  The outside face of  

 the bracket's top flange goes against the bottom side of the 1047C  

 stiffener, while the inside face of the bracket's bottom flange goes  

 against the bottom side of the 1047D stiffener.  The instructions  

 have a drawing that makes this arrangement perfectly clear.



 --------

 Todd Stovall

 728TT (reserved)

 RV-10 Empacone





 Read this topic online here:



 http://forums.matronics.com/viewtopic.php?p 27784#227784

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

westexflyboy

Joined: 02 May 2008
Posts: 9
Location: Presidio, TX

Posted: Fri Jan 30, 2009 9:49 pm Post subject: Re: Van's Whelen/ELT bracket

 	  Jim Berry wrote: 	
		  It will not fit on the right, but it would be easy to make a mirror image if you wanted one for elt and one for strobe pack 	




Vans sells this same part in mirror image for the right.  Search the onlike catalog for F-10112-R

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

_________________
Chase Snodgrass
Presidio, Texas
www.flybigbend.com
Simultaneous RV-10 twins under construction

msausen

Joined: 25 Oct 2007
Posts: 559
Location: Appleton, WI USA

Posted: Sat Jan 31, 2009 8:00 am Post subject: Van's Whelen/ELT bracket

Thanks guys, I figured it was mounted to the J Channel.  That's basically what I needed as I'm looking for someplace to mount my Mountain High tank filler.  Mine is the one with the gauge otherwise I would have mounted it through the rear bulkhead somewhere.



Michael

Do not archive



--

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

tsts4

Joined: 06 Aug 2007
Posts: 167
Location: Tampa, FL

Posted: Sat Jan 31, 2009 8:12 am Post subject: Re: Van's Whelen/ELT bracket

I just faxed a copy to Jesse so he can post.

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

_________________
Todd Stovall
aka "Auburntsts" on EAA and VAF
RV-10 N728TT -- Flying

planesmith(at)hotmail.com
Guest

Posted: Sat Jan 31, 2009 10:42 pm Post subject: Van's Whelen/ELT bracket

Hi Michael C



Probably a little late C but I posted some pictures of the installed mounts on the blog: www.aviationstop.com



Vern Smith (#324 finishing)



[quote] From: rvbuilder(at)sausen.net

 To: rv10-list(at)matronics.com

 Date: Sat C 31 Jan 2009 09:38:46 -0600

 Subject: RE: Re: Van's Whelen/ELT bracket

 

 --> RV10-List message posted by: "RV Builder (Michael Sausen)" <rvbuilder(at)sausen.net>

 

 Thanks guys C I figured it was mounted to the J Channel.  That's basically what I needed as I'm looking for someplace to mount my Mountain High tank filler.  Mine is the one with the gauge otherwise I would have mounted it through the rear bulkhead somewhere.

 

 Michael

 Do not archive

 

 --

- The Matronics RV10-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?RV10-List

Display posts from previous:

	Matronics Email Lists Forum Index -> RV10-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum