Matronics Email Lists :: View topic - Dual trim indicator buffer

Matronics Email Lists
Web Forum Interface to the Matronics Email Lists

Get Email Distribution Too! FAQ Search Memberlist Usergroups Register

Profile Log in to check your private messages Log in

Dual trim indicator buffer

Matronics Email Lists Forum Index -> AeroElectric-List

View previous topic :: View next topic

Author Message

nuckolls.bob(at)aeroelect
Guest

Posted: Sun May 04, 2014 5:42 am Post subject: Dual trim indicator buffer

Here's the drawing I alluded to last night . . .



http://tinyurl.com/pdacqjp



Had a power failure yesterday afternoon which

led to a discovery that my AutoCAD backup feature

had not been set up on this machine . . . lost

90% of the work and had to put it back together

this morning.



Well considered critical review from kindred herders

of electrons is solicited and welcome.



This project could be laid up on a board that

would fit into a 15 pin d-sub housing. The pots

will allow adjustment of gain over a 1 to 2x range.

Offset is good for about 30% of range. This will

allow a builder to make the trim indicator display

full, as-installed stroke of the actuator.

   Bob . . .

- The Matronics AeroElectric-List Email Forum -

Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:

http://www.matronics.com/Navigator?AeroElectric-List

Display posts from previous:

	Matronics Email Lists Forum Index -> AeroElectric-List	All times are GMT - 8 Hours
Page 1 of 1

Jump to:

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You can download files in this forum