tomhanaway
Joined: 12 Aug 2006 Posts: 111 Location: Murphy, NC
|
Posted: Sun Sep 16, 2007 3:34 pm Post subject: wiring runs and aC43.13-1B Chapter 11-Section 11-clamping |
|
|
I see most builders run their wing wiring through the grommets in the wings and in the side panels. Especially where surrounded by conduit. Makes sense to me.
I'm trying to figure out Section 11 of "acceptable methods" Aircraft Inspection, Repair and Alterations which seems to call for a cushion clamp even when running through a grommet where the wires are less than 3/8" from the hole edge.
Could someone give me some guidance.
Thanks,
Tom Hanaway
| - The Matronics RV10-List Email Forum - | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
|
|