Bob Marshall
Joined: 23 Dec 2010
Posts: 3
|
 Posted: Wed Jan 04, 2012 10:02 am Post subject: Hall Effect Current Sensor with Z13/8 |
 |
|
My RV6A is being built based on Z13/8 with dual Dynon EFIS and an SD-8 back up alternator. Dynon has just updated its EFIS to allow installation of the GRT CS-01 Hall Effect Current Sensor (in addition to the standard loadmeter shunt at the alternator) and I was wondering what the consensus was as to where to place it. I want to read total amps being used when the main alternator is off line. So, my initial thought would be to place it on the main (#2 AWG) conductor from the Battery to the Battery Contactor. This would give me total amps with the Main Alternator on-line and total amps with the main off-line and the SD8 on- line?
I could also place it exactly where the shunt is shown for the SD-8 and that would just give me SD8 output?
Thanks for any thoughts on this.
Bob
| | - The Matronics AeroElectric-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?AeroElectric-List |
|
| Description: |
|
Download |
| Filename: |
AMP_HE_Rev_B.pdf |
| Filesize: |
15.97 KB |
| Downloaded: |
264 Time(s) |
_________________
RV-6A construction resumed. Planning electrical and building wing. |
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
